4. Use a Scanner to Determine if the VSS is Reporting any Speed. Plug a good scanner into the OBD II port. You can configure it to report the vehicle’s speed as reported by the VSS. If it says 0 MPH while driving, the VSS has likely caused your Mazda 6’s speedometer to stop working. The video below shows exactly how to use a scanner to test
When determining if your Mazda 3’s fuel pump is going bad, there are a few common symptoms to look out for. Here, we’ll discuss three key indicators that your fuel pump might be failing. 1. Whining Noise. The sound clip above is a fuel pump priming. After it has primed, you may hear a high-pitched whining noise, which can indicate a fuel
Hi everyone. I had the same problem with my 2004 Mazda 6 diesel. Stalling when idling, worse in cold weather. Also I noticed in cold weather it would idle around 750 revs per minute-before this problem it would always rev at just under 1000 revs per minute.
So far this year we have had four Mazda 6 Skyacctiv Diesels with low oil pressure problems in our workshop and each car had to have a full engine rebuild. Each customer I spoke to told me the same thing, they got no where with Mazda and and they eventually came to a decision that the engine failure was the customers fault and not a design fault.
The 2006 Mazda 5 gained a reputation as the worst Mazda 5 model year you could get. It had the most suspension problems which are expensive to repair. It also had more severe forms of clutch and accessory problems and a high risk of a blown engine. The 2007 and 2008 models inherited some of the 2006 model’s problems, but not with the same
. 173 475 295 453 33 80 59 126
mazda 6 2.0 diesel problems
